7
7.33
9924864 - 2012-2014 SPORTSMAN 800 / 6X6
© Copyright 2013 Polaris Sales Inc.
5. Place the piston in the piston cavity, aligning the pins
with the pin bosses. Using the casting and piston
marks as a guide as shown will aid pin alignment.
6. Place ADC Piston Tool PA-48542 on top of the piston
and verify alignment of the sight hole (circled) and
piston mark with the casting marks. Support the case
and press the piston down evenly. The piston is fully
seated and located in the pin bosses when the piston
surface is just below the cavity edge.
FINAL DRIVE
To Next Page
Loading...
