ENGINE
3.51
OILRELIEFVALVEINSTALLATION
Install the oil relief valve, spring, and plug using a new
sealing washer.
CAM CHAIN DRIVE SPROCKET INSTALLATION
1. Install the Woodruff key, drive sprocket, and
slotted nut. Tighten the nut to the specified torque.
TENSIONER BLADE INSTALLATION
1. Install the tensioner blade and tighten the
mounting bolt to specified torque.
OIL FILTER INSTALLATION
1. Apply clean engine oil to oil filter gasket. Install
filter until gasket lightly touches seat and then
tighten an additional 3/4 of a turn.
Oil Relief Valve Plug Torque:
14-17 ft. lbs. (19-23 Nm)
A
B
T ighten
Slotted Nut Torque:
35-51 ft. lbs. (47-69 Nm)
Tensioner Blade Mounting Bolt Torque:
5-6.5 ft. lb s. (7-9 Nm)
Oil Filter Connector Torque:
36-43 ft. lbs. (49-59 Nm)
To Next Page
Loading...
