ENGINE
3.31
ENGINE BOTTOM END DISASSEMBLY
CYLINDER REMOV
AL
Follow engine disassembly procedures to remove valve
cover, camshaft and rocker arms, and cylinder head.
1. Remove cam chain guide at front of cylinder.
2. Remove the two 6 mm cylinder base bolts.
3. Tap cylinder lightly with a plastic hammer in the
reinforced areas only until loose.
4. Rock cylinder forward and backward and lift it from the
crankcase, supporting piston and connecting rod.
Support piston with piston support block PN 2870390.
5. Remove dowel pins from crankcase.
To Next Page
Loading...
