CLUTCH
6.26
DRIVEN CLUTCH DISASSEMBLY/INSPECTION
Used to adjust
belt tension. One must
always be installed.
CAUTION:
Wear eye protection when removing snap ring to prevent serious personal injury.
1. Apply and hold downward pressure on the helix, or
place driven clutch in compressor tool PN 8700220.
2. Remove snap ring retainer.
3. Note location of spring and remove helix.
4. Note location of spring in the moveable sheave, and
remove the spring.
Note hole location of spring
in helix and sheave
To Next Page
Loading...
