CLUTCH
6.25
DRIVE CLUTCH COVER - BUSHING INSTALLATION
1. Apply Loctite 680 retaining compound to the back
side of new bushing. Working from inside of cover,
insert bushing and bushing installation tool into
center of clutch cover.
2. With main adapter on puller, insert cover onto puller
rod, placing outside of cover toward vise.
3. Install nut on rod and hand tighten. Turn puller
barrel to apply more tension if needed.
4. T urn clutch cover and barrel together
counterclockwise on puller rod until bushing is
seated.
5. Remove nut from puller rod and take installation
tool and clutch cover off rod.
Bushing PN 3576510
Loctitet 680 PN 2870584
To Next Page
Loading...
