TRANSMISSION
8.9
TRANSMISSION ASSEMBLY
1. Assemble input shaft assembly.
NOTE:
Install bearings with numbers and letters facing
out so they can be read after assembly. Sprocket cogs
face the dog gear.
NOTE:
Input gear cogs face inward on input shaft.
2. Assemble output shaft with sprocket, gear and
bearing if they were disassembled.
3. Assemble output shaft assembly with chain to the
input shaft assembly.
4. Install shift shaft, driven sprocket and gear into the
case.
5. Install shift fork.
6. Insert fork guide pin.
Input Shaft
Bushing
Sprocket
Dog Gear
Input Gear
Thrust Washer
To Next Page
Loading...
