BODY/STEERING/SUSPENSION
5.1
TORQUE SPECIFICATIONS
Front A-Arm Attaching Bolt 30 ft. lbs. (41 Nm).................
Front A-Arm Ball Joint Stud Nut 25 ft. lbs. (35 Nm).............
Handlebar Adjuster Block 10-12 ft. lbs. (14-17 Nm)...................
Master Cylinder 45-55 in. lbs. (5.2-6.3 Nm)...........................
Rear Axle Nut - (Tapered Roller Bearings)
(Left side) 120 ft. lbs. (165 Nm)................................
(Right side) 8-10 ft. lbs. (11-14 Nm)...............................
Rear Shock Bolt (upper) 25 ft. lbs. (35 Nm)....................
Rear Shock Bolt (lower) 25 ft. lbs. (35 Nm)....................
Rear Wheel Hub Nut 80 ft. lbs. (110 Nm)......................
Rear Wheel Nut 50 ft. lbs. (69 Nm)...........................
Strut Rod Retaining Nut (Top) 15 ft. lbs. (21 Nm)...............
Strut Casting Pinch Bolt 15 ft. lbs. (21 Nm)....................
Swing Arm Pivot Bolt 150 ft. lbs. (207 Nm)......................
T ie Rod End Jam Nut 12-14 ft. lbs. (17-19 Nm)......................
T ie Rod End Castle Nut 23-24 ft. lbs. (32-33 Nm)....................
T ie Rod End Attaching Bolt 25-30 ft. lbs. (35-41 Nm).................
NOTE: Refer to exploded views throughout this chapter for identification and location of components.
SPECIAL TOOLS
Description Part No.
Strut and Ball Joint Tool Set 2870871..........
Shock Spanner Wrench 2870872.............
Shock Spring Compressor Tool 2870623.......
Strut Rod Holding Wrench 2871572...........
Strut Spring Compressor Tool (LH) 2871573...
Strut Spring Compressor Tool (RH) 2871574...
Optional Fox¥ Shock Tools
Body Holding Tool 2871017..................
Safety Needle 7052069......................
Shock Spring Compressor Tool 2870623.......
Gas Shock Recharging Kit 2200421...........
Damper Rod Holding Tool 2871352...........
Fox¥ Shock IFP Tool 2871351...............
To Next Page
Loading...
