TRANSMISSION
8.2
TRANSMISSION REMOVAL
1. Remove seat, cab and air box.
2. Remove right side heat and reservoir bracket.
3. Remove PVT outer cover, both drive and driven
clutch, and inner PVT cover (refer to Clutch Chapter
6).
4. Remove rear PVT bracket.
5. Remove carburetor.
6. Disconnect harness from gear position switch.
7. Remove drive chain and sprocket.
8. Remove mounting bolts and brackets as shown.
9. Remove through-bolt from bottom of transmission.
10. Remove transmission from right side of frame.
TRANSMISSION INSTALLATION
1. Reverse removal steps to install transmission.
NOTE: Install center distance tool PN 2871710 on en-
gine and transmission input shaft before tightening trans-
mission mounting bolts. Align clutches as outlined in
Clutch Chapter 6.
To Next Page
Loading...
