MAINTENANCE
2.27
BRAKE SYSTEM INSPECTION
The following checks are recommended to keep the brake system in good operating condition. Service life of
brake system components depends on operating conditions. Inspect brakes in accordance with the maintenance
schedule and before each ride.
S Keep fluid level in the master cylinder reservoir to the in-
dicated level inside reservoir at all times.
S Use Polaris DOT 3 brake fluid (PN 2870990).
S Check brake system f or fluid leaks.
S Check brake for excessive travel or spongy feel.
S Check friction pads for wear , damage and looseness.
S Check surface condition of the disc.
S Inspect thickness of brake pad friction material.
BRAKE PAD INSPECTION
S Pads should be changed when friction material is worn
to 3/64s (.1 cm), or about the thickness of a dime.
HOSE/FITTING INSPECTION
Check brake system hoses and f ittings f or cracks, deterio-
ration, abrasion, and leaks. T ighten any loose fittings and
replace any worn or damaged parts.
Parking Brake
Lock
Sight
Glass
Min
Max
3/64s
(.1cm)
Minimum
Thickness
To Next Page
Loading...
