MAINTENANCE
2.31
ADJUSTMENT PROCEDURE - CONCENTRIC SWINGARM, CONT.
4. Insert a pin punch through the sprocket hub and
into the eccentric axle housing.
5. Move the ATV forward or back to move the
eccentric housing and adjust to the proper tension
(approx. 3/8s, or 10 mm)
6. T ighten the eccentric clamp bolts to specification.
WITH TRAILER HITCH - 45 ft. lbs. (61 Nm)
CAUTION:DO NOT OVER-TIGHTEN ECCENTRIC
CLAMP BOL TS. PRE-MATURE BEARING F AILURE
MAY RESULT.
WITHOUT TRAILER HITCH - 30 ft. l bs. (41 Nm)
Pin Punch
Torque the nut
Eccentric Clamp With Hitch
Torque the nut
Eccentric Clamp Without Hitch
To Next Page
Loading...
