ENGINE
3.18
AUTOMATIC COMPRESSION RELEASE REMOVAL/INSPECTION
NOTE: The automatic compression release mecha-
nism can be inspected and serviced without removing
the camshaft from the cylinder head.
1. Check release lever shaft for smooth operation
throughout the entire range of rotation.
2. Remove release lever shaft and return spring
(spacer).
3. Inspect shaft for wear or galling.
4. Inspect lobe on end of release lever shaft for wear
and replace if necessary.
AUTOMATIC COMPRESSION RELEASE INSTALLATION
1. Slide spring onto shaft.
2. Apply engine oil to release lever shaft.
Lobe
To Next Page
Loading...
