ENGINE
3.42
OIL PUMP ASSEMBLY
1. Clean and dry all parts thoroughly. Apply clean engine oil to all parts. Do not use gasket sealer on the pump
cover mating surfaces or clearances will be incorrect, and oil passages may become plugged.
2. Install outer feed rotor and inner feed rotor drive pin.
3. Install inner feed rotor and feed chamber cover with screw.
4. T ighten screw securely.
5. Install oil pump on crankcase and torque bolts to 6 ft. lbs. (8 Nm).
CRANKCASE SEPARATION
1. Remove flange bolts (11) from magneto side
crankcase evenly in a criss-cross pattern.
2. Separate crankcase by tapping with a soft faced
hammer in reinforced areas.
3. W atch the gap along the crankcase mating surface
and separate the crankcase evenly.
4. Remove the Mag (RH) crankcase from the PTO case.
Oil Pump Attaching Bolt Torque:
6 ft. lb s. (8 Nm)
To Next Page
Loading...
