36
OPERATION
Starting the Engine
Starting a Cold Engine
1. Place the t ransmission in neutral.
2. Lock the parking brake.
3. Sit in the driver’s seat and fasten your seat
belt.
4. Pull the choke knob (1) all the way out.
5. Turn the ignition key to START.
6. If the engine does not start within five
seconds, release the ignition switch and
wait five seconds. Turn t he ignition switch
to START for another five seconds.
Repeat this procedure until engine starts.
NOTE: Do not press the throttle pedal while starting the engine.
7. If the engine slows or stops, push the choke knob in half way.
8. Vary the engine RPM slightly with the throttle to aid in warm up
until the engine idles smoothly. Then push the choke all the way
in.
Engine exhaust contains poisonous carbon monoxide and can
cause loss of consciousness resulting in severe injury or death.
Never run an engine in an enclosed area.
WARNING
Operating the vehicle immediately after starting could cause
engine damage. Allow the engine to warm up for several
minutes before operating the vehicle.
CAUTION
1
CAUTION
Do not operate the starter continuously for more than five seconds
or the starter will overheat and the battery power will drop
temporarily. Wait at least five seconds between each operation of
the starter to allow it to cool and to allow battery power recovery.
Do not turn the ignition switch key to the START position while the
engine is running. Damage to the starter can result.
To Next Page
Loading...
Need help?
General
