64
MAINTENANCE AND LUBRICATION
Gearcases
Transmission (Main Gearcase)
The transmission lubricant level should be checked at 25 hours or
monthly, whichever comes first. Transmission oil should be changed
annually.
NOTE: Refer to the Gearcase Specifications Chart on page 67.
Always use Polaris Premium Synthetic Gearcase Lube. See page 98
for the part numbers of Polaris-recommended products.
Oil Check
1. Position the vehicle on a level
surface.
2. Remove the fill plug (1), which is
located on the right-hand side of the
vehicle.
3. Check the lubricant level. Lubricant
should be even with the bottom
thread of the fill plug hole. Add
Polaris P remium Synthetic Gearcase
Lube if necessary. See page 98 for
the part numbers of
Polaris-recommended products.
4. Reinstall the fill plug and torque to specification.
Oil Change
1. Remove the skid plate (if necessary).
2. Remove the fill plug.
3. Remove the drain plug and drain the
oil i nto a drain pan. Dispose of used
oil properly.
4. Wipe the magnetic end of the drain
plug clean to remove accumulated
metallic filings.
5. After the oil has drained completely,
install a new sealing washer and
reinstall the drain plug. Torque to
specification.
6. Add Polaris Premium S ynthetic Gearcase Lube until the oil level is
even with the bottom thread of the fill plug hole. Do not overfill.
7. Reinstall the fill plug and torque to specification.
8. Check for leaks.
9. Reinstall skid plate if removed.
1
2
To Next Page
Loading...
Need help?
General
