Polaroid 100 Series User Manual

:lInt :lml insf<lll 0I1l" sprinl!- on th~ shaft at th~
inho;ml sid\.' of the- bur. 1llSl..'rt the shuH
thruugh the'
~lid~ block. Install the remain!n,!!:
sprin~ on the- shaH and slid~ the shaft
through the other slot in the edge control
bar.
3. Swing the t-'Ovcr over the slide block and reo
place- the Three retaining screws. CAUTION:
BE SURE THE SHAFT DOES NOT JAM
UNDER THE SLIDE BLOCK COVER.
SPREAD ROLL SPRING REPLACEMENT
Removal
1. Open the rear door. unlatch the rollers and
remO\'e the rear rolJ (Fi~rc 5~5.: Hold the
fr.lme roller support and press finnly lJg<linst
the rear rolL Appfy an upward foree :.gainst
one end of the roll until the roll and bush-
in~ disen~ge from the support.
EDGE
... ____ CONTROl
5.4 REPLACING THE EDGE CONTROL BAR
eAR
St.IOE
FIG
Ff:\AME f:\Ot.t.EA
SUI'I'ORT
I
/' BUSHING
REAR
AOt.L
FIG.5.5 REMOVING THE REAR ROLL
40

Polaroid 100 Series Specifications

General

Image Sensor	CCD
Optical Zoom	3x
Digital Zoom	4x
Shutter Speed	1/2 - 1/2000 sec
Video Resolution	640 x 480
Storage Media	SD card
Battery Type	2 x AA