Polaroid 100 Series User Manual

RF!Vr In Ilh,' !.:.mll.'r~1 i Figun' 541).
IX-tl1,.'lluinll' on whether Ihcr~ arc ht.'x-hcad
s:eww)\ or Phillips-head s .... rews. me tool
#AI.OIl2 or#AI 1093 10 remove them.
Retain lin: haruwarc. Lift the RF/VF off
Ihl! 1.',IJlll!r;J.
Reptou."t'meIU
I. Position the RF/VF on the camera, Be sure
the focus bar bracket
is to the left of the
RF/VF pick-ilp link as .ho .... in Figure 54!.
,
U'in~ tool #All 091 or #A 11093 replace
(he holding hardwOIre at the front of the
C'.;menj,
3, Extend the bellows to detent lock-in and
repJace the Pb.iJJips--head screw holding the
RF/VF.
4. Perform the applicable RF!VF checks
described in
Section III.
REPLACEMENT OF FOLDING
RANGEFINDER/VIEWFINDERS
Removal
Using special
tool #169451 as shown in Figure
5-42. remove
the Jeft hinge pin. Retain the pin
and the spring. Lift the
RF/VF free of the
camera,
FIG. 5.42 FREEING THE RFNF
Replacement
Set the focus bar 10 INFINJTY, Nexi. position
Ihe new
RF!VF on the camera and place the
srrin" in position belween the left hinge pin and
the rrVOf pad, (Be sure the focus bar bradet is
." .he Iri. "r.he RFIVF pick-ilp link as sh" ....
in Figure 543.) Usc !\:p\!dal tool #1 69451 (as
l'ihuwo in Fi#-urc 543) to drive the left hinge pin
into position, Swivel the RF/VF into the Jarscd
position and listC'D for binds. Perform the applj~
l.-dbie RFNf \!hecks described in Sectio.n III.
o
FIG. 5.43 INSTALLING A FOLDING RFNF
REPLACEMENT OF POLAROID RF/VF
OI'TICS
ASSEMBLY & VF WINDOW
Removal
!.
Remove the rear window plate from the
RF/VF by removing the two retain.ing
screws.
,
lJnhook the spring (Figure 544) from the
optics assembly tab, Allow the spring to
slide under the tab,
FIG. 5.44 REMOVING THE OPTICS ASSEMBLY

Polaroid 100 Series Specifications

General

Image Sensor	CCD
Optical Zoom	3x
Digital Zoom	4x
Shutter Speed	1/2 - 1/2000 sec
Video Resolution	640 x 480
Storage Media	SD card
Battery Type	2 x AA