Important Safety Instructions
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
Important Safety Instructions
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
a. Use No.10AWG (5.3mm
2
) copper, No.8 AWG (8.4mm
2
) aluminum, No.17AWG (1.0mm
2
)
copper-clad steel or bronze wire, or larger, as a ground wire.
b. Secure antenna lead-in and grounding wires to house with insulators spaced from 4-6 feet
(1.22-1.83m) apart.
c. Mount antenna discharge unit as close as possible to where lead-in enters house.
d. Use jumper wire not smaller than No.6AWG (13.3mm
2
) copper, or the equivalent, when a
separate antenna grounding electrode is used.
FIGURE A
EXAMPLE OF ANTENNA
GROUNDING ACCORDING TO
NATIONAL ELECTRICAL CODE
INSTRUCTIONS
ON PLACEMENT
•
Do not use the unit in places which are extremely hot, cold, dusty or humid.
•
Place the unit on a flat and even surface.
•
Do not restrict the air-flow of the unit by placing it in a location with poor ventilation,
covering it with a cloth or by placing it on a carpet.
ON CONDENSATION
•
When left in a heated room where it is warm and damp, water droplets or condensation
may form inside the unit.
•
If there is condensation inside the unit, the unit may not function normally.
•
Let it stand for 1 to 2 hours before turning the power on, or gradually heat the room up and
dry the unit before use.
CAUTION:
Remove AC plug from wall outlet and the batteries from battery compartment of the remote control
when the unit will not be used for a prolonged period.
HIGH VOLTAGE:
Live voltage parts are accessible when the rear cover is removed.
Please read IMPORTANT SAFETY INSTRUCTIONS
Excessive sound pressure from earphones and headphones can cause hearing loss .
NOTES:
- Periodically inspect for damage: if damaged, properly repair the TV before use.
- Adult supervision recommended.
To Next Page
Loading...
Need help?
General