7 COMMUNICATION WITH COMPUTER
The РМ1703МО-1 is equipped with infrared data exchange capabilities.
PM1703MO1 Data Processing Software must be installed on your personal computer in
order to be able to communicate with the instrument.
This communication allows the user to set advanced instrument parameters,
download event data stored in the instrument memory to the database and perform other
operations. Please see the “PM1703MO1 Data Processing Software Guide” for more
information.
Whenever information about exceeding a threshold value is stored in the
instrument memory, the LCD screen indicates it by a blinking “h” (HISTORY) sign.
This sign disappears after the information is read from the instrument memory by the
PM1703MO-1 Data Processing Software.
To initialize the infrared communication, place the instrument 3 to 4 inches away
from the infrared adapter and press the Light button. When the РМ1703МО-1 enters the
Data Communication Mode the message “IR” is displayed on the LCD screen.
As soon as the instrument’s operation history is transferred it is deleted from the
instrument memory and the instrument is turned off automatically.
8 TROUBLESHOOTING
In the field, troubleshooting is limited to replacing the battery. Most of the yet
encountered problems have been reported to be because of low battery or poor battery
quality. To operate this instrument, use only fresh, high-quality alkaline batteries. The
РМ1703МО-1 requires very little energy which means that while troubleshooting the
unit should be allowed to stand without the battery for 1-2 minutes to allow the internal
circuits to discharge. Discharging the remaining battery power is especially important if
the user is experiencing problems with the unit.
16
To Next Page
Loading...
Need help?
General
