POLMAR DB-2 - Page 61

57
Press[ ]key+numberkey[ ]toenterfrequencystepsetting.Rotatethe
DIALknobtoselect5/6.25/10/12.5/25.0/37,5/50.0/100.0KHz.
7. VOXswitchon/offsetting(F+7)
Press[
]key+numberkey[ ]toenterVOXswitchon/offsetting.Rotate
theDIALknobtoselectON/OFF.
RegardingVOXlevelsettingpleaseseeMENUOPERATIONITEM23.Page36.
8. FMradiomode
Press[
]key+numberkey[ ]toenterFMradiomode.AFMiconwillap-
pearonthebottomoftheLCD.
RotatetheDIALknobtoselectFMfrequencyordirecUyinputthefrequency
bykeypad.
FMradiofrequencyrangeis76.00-108.00MHz.Press[
]key+numberkey
[
]againtoexit.
UnderFMRadiomode,DB-2canmonitorthereceiversignals.Whenthereisa
call,DB-2willexitFMradiomodetemporarilyandreceivethecall.Afternish-
ingthecallfor5seconds,retumbackFMradiomodeautomatically.
9. Keypadbeepersetting
Press[
]key+numberkey[ ]toenterkeypadbeepersetting.Rotatethe
DIALknobtoselectOFF/TONE/VOICE.
10.CTCSS/DCSsetting
Press[
]key+numberkey[ ]toenterCTCSS/DCSsetting.
1.SwitchbetweenRXandTXvia[
]key.
2.SwitchbetweenCTCSSandDCSvia[
]key.
OFF->CTCSS->DCSN->DCS1->0FF
3.RotatetheDIALknobtoselectCTCSS/DCS.