Polyaire airtouch - Assign a Sensor to a Group; Pair Main Module and Wireless Sensors (Itcs); Calibrate a Sensor

21
5.3.1 Assign a sensor to a group
The console sensor can be assigned to a group where it’s installed in Parameter
settings. For a wireless sensor, open the wireless sensor cover and set the dial of
the group dipswitch (with 16 digits) pointing to the group number required.
Position 0 is for group 16. If there are more than one wireless sensor for the same
group, set the group dipswitch to the same position but dierent sensor ID by
switching the Sub ID dipswitch. If the group dial switch or sub ID switch has been
changed after pairing it’s necessary to re-pair the sensor. Otherwise the change
will not be eective.
5.3.2 Pair main module and wireless sensors (ITCs)
After assigning wireless sensors to relevant groups, it’s time to pair the sensors.
The AirTouch 4 main module and wireless sensors have to be paired to enable
communications. When AirTouch 4 is rst powered up, start the pairing process
on the Sensors page in the Installer’s Settings by switching the Pair button to Start,
then push and hold the button on each of the ITCs to be used in the system to
pair. All ITCs will come up and the groups with ITCs will show set points after being
paired. Then switch the Pair button to Stop to nish the pairing process.
5.3.3 Calibrate a Sensor
If the temperature reading from the sensor is not accurate, it can be calibrated by
changing the value in the calibration box on the sensor details page. Press Save
button to save the correct value.
Sensors contd.