User Guide SoundPoint IP 330/320
1 - 8
2. On the back of the phone, remove the key located behind the hook switch
and reposition it so that the end tab (at a 45
0
angle) is facing up.
3. Using wall anchors (not included), fasten the base stand with the
mounting tab facing up.
4. Align the base stand tabs with their corresponding insertion points on the
phone, and then snap the phone into place (as shown).
Registering the Phone
Generally, your phone will be deployed with multiple other phones. In this
case, your system administrator will configure the phone parameters
beforehand, so that after you set up your phone, the phone will be registered
and ready to use.
If your phone is not part of a large phone deployment, your phone may not be
registered after you set it up. Before you use your phone, you or your system
administrator will have to register it. For detailed information on how to
To Next Page
Loading...
Need help?
General