Polycom VoiceStation 500 - Initiating Bluetooth Mode; Configuring the VoiceStation 500 for Bluetooth Mode; Using VoiceStation 500 with Bluetooth-Enabled Mobile Phone; Making and ending a Bluetooth mobile phone call

VoiceStation™ 500 - 9
be established within 60 seconds,
VoiceStation™ 500 will revert to
POTS mode.
Initiating Bluetooth Mode:
Conguring the VoiceStation™ 500 for
Bluetooth Mode
1. Press the Mode button to enter Blue-
tooth mode. The blue Mode LED
should be on (either slow blinking or
steady).
2. Press the Mode button again. Hold
for at least 3 seconds and ensure the
blue LED is fast blinking (discover-
ing).
You will hear a series of tones on
VoiceStation™ 500 indicating
that your Bluetooth device has
discovered and paired with the
VoiceStation™ 500.
On your Bluetooth device, select
VS500 as the discovered device and
when prompted for the Password,
enter ‘0000’. Once the Bluetooth-
enabled device is paired and linked
with VoiceStation™ 500, the blue
LED should be steady (On). A con-
rmation tone will also be heard on
the VoiceStation™ 500.
3. Refer to the following sections for
use with either a mobile phone or
computer.
Using VoiceStation™ 500 with
Bluetooth-Enabled Mobile
Phone:
Making and ending a Bluetooth mobile
phone call
1. Press the Mode button to enter Blue-
tooth mode. The blue Mode LED
should be on (steady).
2. Dial the phone number on the Blue-
tooth-enabled mobile phone or press
the On/Off button on VoiceStation™
500 to dial the last dialed number on
the mobile phone.
3. When nished, terminate the call
as you normally would with your
mobile phone, computer or press the
On/Off button on VoiceStation™
500.
Answering a mobile phone call on
VoiceStation™ 500
1. Ensure the mobile phone is paired
and linked with the VoiceStation™
500. See “Initiating Bluetooth
Mode” for more information.
2. When the mobile phone rings, an-
swer the call on your mobile phone
as you normally would or
3. Press the On/Off button on the
VoiceStation™ 500.
Ending the mobile phone call using
VoiceStation™ 500
1. Disconnect the call on your mobile
phone as you normally would, or ;
2. Press the On/Off button on the
VoiceStation™ 500.
Redialing the last dialed number using
VoiceStation™ 500
• Press the On/Off button on
VoiceStation™ 500 to dial the last
dialed number on the mobile phone.
NOTE: If you are in Bluetooth mode
and want to make a POTS call, you
must rst push the Mode button to
exit Bluetooth mode, then press the
On/Off button to initiate the POTS
call.