Polycom VSX Series

Chapter 3 - System Commands
© Polycom, Inc. 3 - 21
alertvideo-
tone
alertvideotone
<1|2|3|4|5|6|7|8|9|10get>
Where:
• 1, 2, 3, 4, 5, 6, 7, 8, 9, or 10: Sets the
incoming video alert to the
corresponding tone.
•get: Returns the current alert video
tone setting (1, 2, 3, 4, 5, 6, or 7).
Sets the tone used for incoming
video calls.
User interface screen location:
System > Admin Settings >
Audio: Incoming Video Call
alertusertone 8
allowmixed-
calls
allowmixedcalls <yes|no|get>
Where:
• yes: Enables mixed IP and ISDN
calls.
• No: Disables mixed IP and ISDN
calls.
• get: Returns the current setting (yes
or no).
Sets or gets the ability to place
and receive mixed protocol mul-
tipoint calls (IP and ISDN). It
allows the administrator to dis-
able this ability for security
reasons.
User interface screen location:
System > Admin Settings >
General Settings > System
Settings > Call Settings:
Allow Mixed IP and ISDN Calls
Note: This option is only visible
on screen if ISDN and IP have
both been enabled on the Call
Preference screen.
allowmixedcalls
yes
allow-
streaming
allowstreaming <yes|no|get>
Where:
• yes: Allows streaming calls.
•no: Disallows streaming calls.
•get: Returns the current setting (yes
or no).
Adds Streaming to the Utilities
screen so that users can start
streaming calls.
User interface screen location:
System > Admin Settings >
Network > IP > Streaming:
Allow Streaming
allowstreaming
yes
answer answer video
Where:
•video: Answers incoming video
calls when the Auto Answer Point to
Point or Auto Answer Multipoint
option is set to No.
Answers incoming video calls. answer video
Command Syntax Description Example