Polycom VSX Series - Actions that Cause the System to Restart

Administrator’s Guide for the VSX Series
Appendix - 10
Actions that Cause the System to Restart
The VSX system restarts in the following situations:
• Changing Monitor 1 configuration from non-VGA to VGA, or from VGA
to non-VGA. If the VSX system is connected to a single VGA monitor, you
must hold down the asterisk button on the remote control while the
system restarts.
• Changing any of the following settings in the LAN Properties screens:
—Connect to My LAN
— Host Name
— IP Address — Changing how the system obtains an IP address or
changing the address that you have entered manually
—DNS Servers
— Default Gateway
— Subnet Mask
— WINS Server
—LAN Speed
— Duplex Mode
• Changing any setting under Enable Remote Access, on the Security
screen:
—FTP
—Web
— Telnet
—SNMP
• Changing the Web Access Port on the Security screen
• Changing any setting on the SNMP screen:
— Enable SNMP
— Community
—Contact Name
—Location Name
— System Description
— Console IP Address
• Changing the Security Mode setting