Block and unblock Caller ID
Your administrator controls the Caller ID settings for
your organization. When Caller ID is turned on, your
number appears on the phone you call. If permitted
by your organization, you can block your line’s Caller
ID on a per call basis.
Temporarily block Caller ID:
• Enter *67 and the number you want to call.
• Press the Dial soft key.
Your administrator can also block your line’s Caller
ID for all calls. You can unblock your line’s Caller ID
on a per call basis.
Temporarily unblock Caller ID:
• Enter *82 and the number you want to call.
• Press the Dial soft key.
Register or reboot your phone
There will be times when you must reset your phone
so that it can retrieve crucial software updates and
configurations from the AT&T Voice DNA service.
• Select the Home button.
• Select Settings.
• Select Basic.
• Select Restart Phone.
Note: The Polycom logo will appear in the display
window for a short time. Once the logo disappears,
the phone is operational.
AT&T Voice DNA Voicemail
You can listen to your AT&T Voice DNA Voicemail
messages using any touchtone phone (IP, wireline or
wireless).
New voicemail message
• Flashing red indicator light
• Envelope in graphic display
To retrieve messages:
• Press the Messages button.
• Select the Connect soft key to dial voicemail.
• Enter your voicemail PIN to access messages.
To Previous Page
Loading...
Need help?
General
