Care and maintenance
14 Installation and Operation Guide
Care and maintenance
Replacing the ēno stylus tip
To replace the ēno stylus tip:
1. Remove the existing stylus tip by pulling it out.
2. Firmly push the replacement tip into the stylus until it snaps into
place.
How to obtain replacement parts
Replacement parts are available directly from PolyVision. Call
1.800.620.POLY (7659) in the USA, 678.542.3100 from elsewhere in
North America, or +32 (0)89 32 31 30 in Europe. You can also send e-mail
to info@polyvision.com.
Technical support
If reviewing the above sections fails to resolve your hardware or driver
problem, contact PolyVision USA Technical Support:
• Phone: 1.800.620.POLY (7659), 678.542.3100
Technical support representatives are available Monday through Friday
from 8 AM Eastern time to 8 PM Eastern time.
• E-mail: support@polyvision.com
• Internet: www.polyvision.com
Or, outside the USA contact PolyVision Europe/Asia Technical Support:
• Phone: +32 (0)89 32 31 30
• E-mail: business.center@polyvision.com
• Internet: www.polyvision.com
FCC compliance
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
when the equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio frequency energy and, if
not installed and used in accordance with the instruction manual, may
cause harmful interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful interference in
To Next Page
Loading...
