Appendix 1: Bluetooth pairing options
PolyVision 17
Note that you can pair several styli with one computer, but a stylus can be
paired with only one computer at a time.
For additional information about PolyVision driver configuration options,
refer to the
PolyVision User Guide
.
Pairing with Windows or Apple built-in Bluetooth
If your computer includes the built-in Windows and Macintosh Bluetooth
capability and you choose not to use the PolyVision Blluetooth adapter for
Bluetooth capability, the PolyVision driver can automatically pair the ēno
stylus with your built-in Bluetooth capability.
To pair your ēno stylus with your computer’s built-in Windows or Apple
Bluetooth capability:
1. Turn on your computer.
2. Turn the ēno stylus on by removing the cap.
3. On your computer, navigate to the Control Panel. For example, in
Windows click the “Start” button, then select “Control Panel.”
4. Click the Bluetooth Devices icon.
5. Select the “Devices” tab and click the “Add” button. This will launch
the “Add Bluetooth Device Wizard.”
6. Click the box that indicates that “My device is set up and is ready
to be found” and click “Next.”
7. You will see a list of all Bluetooth devices. Click the item listed as
“PolyVision Stylus” followed by an associated Bluetooth address.
8. Enter the passcode, which is a number provided on the removable
label on the side of the ēno stylus.
9. Repeat these steps to pair additional styli to this computer.
Note that you can pair several styli with one computer, but a stylus
can be paired with only one computer at a time.
To Next Page
Loading...
