Appendix 1: Bluetooth pairing options
18 Installation and Operation Guide
Pairing with third-party Bluetooth
To use a third-party Bluetooth solution to pair the ēno
stylus with your
computer:
1. Launch the software that comes with your third-party Bluetooth
capability. It may launch from:
• The control panel
• An option in the start menu/programs menu.
• A Bluetooth icon in the taskbar or system menu bar.
2. Turn on the ēno stylus by removing the cap.
3. Locate and start the mechanisms for pairing, such as one of the
following:
• Add a Device
• Pair a Device
• Search for a Device.
The stylus is listed as “ADP-301” and is only visible for a minute or
so after the cap is removed. If you do not see the stylus, replace
the cap, wait two seconds, and remove the cap back again. After
six seconds the stylus is visible to the computer.
4. Follow the prompts from the third-party Bluetooth software. The
general process is as follows:
• Search for Bluetooth devices and select the “ADP-301 stylus.”
• Pair the ADP-301 stylus. When asked, the stylus uses a PIN code or
passkey of 0109.
• After entering the PIN code, the stylus should pair to your computer.
To Next Page
Loading...
