16
5. Installation
5.1 Tools and Safety Gear
NOTE: It is recommended to use proper tools and wear safety gears when
installing.
(1) Slotted Screw Driver
(2) 4mm Inner Hexagonal Screw Driver
(3) Wire Cutter
(4) Insulated Gloves
(5) Safety Goggles
(6) Safety Shoes
5.2 Assemble the Rack
(1) Put the frames and beams together as the figure shown. Pay attention to
the directions of the opening side of beams.
Figure 5.2.1: Put the Frames and Beams Together
(2) Install the screws to fasten the frames and beams.
Opening Side
of the Beams
To Next Page
Loading...