Service training
000
04052000
7.4
25
1. Disconnect the electric cable from the harvester head.
2. Connect a pressure gauge to measurement connector.
3. Start the motor and set the constant pressure:
- engage the working brake and constant rpms
- turn on the harvester head main switch
4. Open the lock and adjust the pressure reducer valve by turning
adjustment screw no. 25 to obtain 120 bar / 1740 psi. (110-130 bar /
1595-1885 psi.).
5. Lock the adjustment screw and connect the electric cable.
Pressure adjustments
Feed roller cylinder pinch pressure
NOTE! BE ESPECIALLY CAREFUL
NOT TO ADJUST THE PINCH
PRESSURE TOO HIGH.
To Next Page
Loading...