lhrn Signal and Lane Change Indicator
The turn signal has two upward
(for
right)
and
two
downward (for left) positions. These positions allow you
to signal a turn
or
a lane change.
To
signal
a
turn,
move the lever
all
the way up or
down.
When the
turn
is finished, the lever will retum automatically.
An arrow on the instrument
panel will flash in the
direction of the
turn
or
1
lane change.
To
signal a lane change, just raise or lower the lever
until
the
arrow starts to flash. Hold it there until you
complete your lane change. The lever will return by
itself when you release it.
As you signal a turn or a lane change, if the arrows don’t
flash but just stay on,
a
signal bulb may
be
burned out
and other drivers won’t see your
turn
signal.
If
a
bulb is burned out, replace it to help avoid an
accident. If the arrows don’t
go
on at all when
you
signal a turn, check the fuse (see “Fuses and Circuit
B&kers” in the Index).
Headlamp
High/Low
Beam
When the high-beams are
on, this light on the
instrument panel also will
be on.
To
change
the
headlamps from low beam to high
or
from high beam to low, pull the turn signal lever all the
way
toward
you.
Then
release
it.
2-47
To Next Page
Loading...
Need help?
General
