Care
of
Safety
Belts
T’:ep
belts cle--
an-’
Cleaning the Outside
of
the
Windshield and
Wiper
Blades
A
CAUTION:
Do
not bleach or dye safety belts.
If
you
do,
it
may severely weaken them. In a crash, they
might not be able
to
provide adequate protection.
Clean safety belts only with mild
soap
and
lukewarm
water.
Cleaning Glass Surfaces
Glass should be cleaned often. GM Glass Cleaner (GM
Part
No.
1050427)
or a liquid household glass cleaner
will
remove normal tobacco smoke and dust films on
interior glass.
Don’t use abrasive cleaners on glass, because they may
cause scratches. Avoid placing decals on
the
inside rear
window, since they
may
have to be scraped
off
later.
If
abrasive cleaners are used on the inside
of
the rear
window,
an
electric defogger element may be damaged.
Any temporary license should not be attached across the
defogger grid.
If
the windshield is not clear after using the
windshield washer, or if the wiper blade chatters
when
running, wax, sap or other material may be
on the blade or windshield.
Clean the outside of the windshield
with
GM
Windshield Cleaner, Bon
Ami@
Powder (non-scratching
glass cleaning powder),
GM
Part
No.
105001
1.
The
windshield
is
clean if beads do not form when you
rinse it with water.
Grime from the windshield will stick to the wiper
blades and affect their performance. Clean the blade
by wiping vigorously with a cloth
soaked
in
full-strength windshield washer solvent. Then
rinse the blade with water.
Check the wiper blades and clean them
as
necessary;
replace blades that look worn.
6-56
To Next Page
Loading...
Need help?
General
