Air Bag Readiness Light
There is an air bag readiness light on the instrument
panel, which shows AIR
BAG.
The system checks the
air bag’s electrical system for malfunctions. The light
tells you if there is an electrical problem. The system
check includes
the
air bag sensors, the air bag modules,
the wiring and the crash sensing and diagnostic module.
For more information on the air bag system, see “Air
Bag” in the Index.
AIR
BAG
This light will come
on
when you start your engine,
and it will flash for a few
seconds. Then the light
should
go
out. This means
the system is ready.
If the air bag readiness light stays
on
after
you
start the
engine or comes on when you are driving, your air bag
system may not work properly. Have your vehicle
serviced right away.
The air bag readiness light should flash for
a
few
seconds
when you
turn
the ignition key to
RUN.
If the
light doesn’t come on then, have it fixed
so
it will be
ready to warn you
if
there is a problem.
Voltmeter
You
can
read
battery
voltage on your voltmeter.
If it reads less than 11 volts
or more than 16 volts while
your engine is running, and
it stays there, you may have
a problem with the
electrical charging system.
Have it checked right away. Driving with the voltmeter
reading in a warning zone could drain your battery.
If you idle your engine for a while, the voltmeter
reading might move into
the
yellow zone. If the reading
stays in the yellow zone while you are driving, you may
have a problem with the electrical charging system.
Have
it
checked. While the voltmeter reads in the yellow
zone, your battery may not be able to power certain
electrical accessories, like
ABS.
(If this happens, your
ABS
INOP
light will come on. See “Anti-Lock Brake
System Warning Light” in the Index.
2-81
To Next Page
Loading...
Need help?
General
