Windshield Wipers
You
control
the
windshield wipers by turning
the
band
with the wiper symbol on
it.
For a single wiping cycle,
turn
the band to
MIST.
Hold
it there until the wipers start, then
let
go. The wipers will
stop after one cycle.
If
you want more cycles, hold the
band on
MIST
longer.
You
can
set
the
wiper speed
for
a
long
or
short
delay
between wipes.
This
can be
very
useful
in
light
rain
or
snow.
Turn
the band
to
choose the delay time. The
closer to
LO,
the shorter the delay.
For steady wiping at low speed,
turn
the band away
from
you
to the
LO
position.
For high-speed wiping,
turn
the band
further,
to
HI.
To
stop the wipers, move
the
band to
OFF.
Damaged wiper blades may prevent
you
from seeing
well
enough
to
drive safely.
To
avoid damage, be
sure
to
clear ice and snow
from
the
wiper blades before using
them.
If
they’re
frozen
to
the
windshield, carefully
loosen or thaw them.
If
your
blades do become
damaged, get new blades
or
blade inserts.
Heavy snow or ice can overload your wipers.
A
circuit
breaker will stop them until the motor cools. Clear away
snow or ice to prevent an overload.
2-48
To Next Page
Loading...
Need help?
General
