POOL LAB ASP PL Series

To Next Page

To Previous Page

DRAIN TUBE

The waste water from testing will be expelled out of the drain tube at the bottom of the

ASP enclosure. It is safe to allow this water to absorb into soil where the installation

location allows this.

The waste water may however cause staining to concrete or paved areas. In this case it

may be preferable to capture the waste water in a container to be disposed of as required,

or otherwise channel the waste water away to a nearby drain or garden bed.

A length of drain tubing is supplied with the unit which may be used to channel the waste

water to a container or drain located directly under the ASP unit.

NOTE: The drain tubing should be kept as near to vertical as possible to allow the waste

water to flow efficiently.

NOTE: Cut drain tubing to length as required - do not loop excess tubing.

NOTE: There are vent holes located at the TOP end of the drain tubing to prevent flooding

of the ASP enclosure if the drain tubing becomes blocked.

NOTE: If draining waste water into a container, ensure the container is vented to avoid

pressure build up.

POOL LAB ASP PL Series - Drain Tube