TROUBLESHOOTING GUIDE
DISPLAY MESSAGE /
SYMPTOM
POSSIBLE CAUSE SOLUTION
Display Message:
“xxx REAGENT EMPTY”
Tests requiring this reagent
will not be performed.
The reagent has failed to
prime. If reagent bag is
empty it will need to be
replaced.
Replace bags if empty and
cycle power to initiate a
reagent prime cycle.
Otherwise check reagent
tubing is fitted correctly.
Check for blockages, kinks
or knots in the tubing.
Display Message:
“LOW FLOW (ASP)”
Water tests, and acid and
chlorine deliveries will not
occur in this state.
The ASP internal flow switch
has not activated.
Check water flow.
Backwash sand filter or
clean cartridge filter if
required, check skimmer and
pump baskets for debris.
Display Message:
“PRIMING REAGENTS”
The reagent prime cycle is
activated. This message is
informational only.
The reagent prime cycle
occurs on initial power up, or
when the prime cycle is
requested via the ASP
TOOLS menu. A partial
prime may also occur during
a water test if an air bubble
was detected in the reagent
line.
If this message occurs
regularly or unexpectedly,
then you may need to
consult an approved service
agent.
Display Message:
“TESTING WATER”
A water test is currently
being performed.
No action required.
Water tests are automatically
scheduled throughout the
filter pump timer cycle.
If tests occur when the pump
is not running, then you may
need to consult an approved
service agent.
Display Message:
“pH CHANGE DET'D”
“ACID FEED PAUSED”
“FOR xx HOURS”
Acid feed will be paused for
the time shown.
A sudden upward shift in the
pH value was detected. This
may occur as the result of
adding alkaline pool
chemicals, such as pH
BUFFER or LIQUID
CHLORINE.
No action required.
To cancel the ACID FEED
PAUSED state and resume
acid feeding, navigate to the
ASP TOOLS, ACID PRIME
view. Press VIEW to cancel
the PAUSED state.
29
To Next Page
Loading...