INSTALLATION SCHEMATIC
The following schematic diagram shows an example of a typical installation.
This example shows a pool and spa combination with a gas heater and integrated solar.
The ASP must be mounted before any heaters or solar equipment, and after the filter.
The ASP must be mounted before the chlorine cell, and before the acid injection point.
The SPA FLOW SWITCH is mounted on the SPA SUCTION line. This is only required for
pool and spa combination systems.
WIRING
Spa Flow switch (Pool & Spa Combination Systems only) must be connected to the Pool
Lab Salt Chlorinator port marked “SPA FLOW”
Peristaltic Acid Pump must be connected to the Pool Lab Salt Chlorinator port marked
“ACID PUMP”.
The Pool Lab ASP power/data cable must be connected to the Pool Lab Salt Chlorinator
port marked “ASP”.
27
To Next Page
Loading...