✓ The regulation instruction in free chlorine probe is configured at 1.0 particle by million by default. If
necessary, you can change this value by using the setting menu :
4/ ORP regulation Option (Poolsquad ®Pro) : Rx
➢ Calibrate the ORP probe.
Put ORP probe in standard solution. Choose value of standard solution (usually 470 mV). You have to
do probe calibration with key OK.
✓ The regulation instruction in free chlorine probe is configured at 650 mV by default. If necessary, you
can change this value by using the setting menu :
FILTRATION TIME
The device is enslaved to the filtration, the chlorine production then directly depends on the calibration of
the day functioning time of your filtration. The setting time of day filtration depends on the evolution of the
water temperature. The more the water is hot, the more you have to filter to maintain the ideal chlorine
rate. During the high season, insure you to calibrate the day filtration time according to the board below :
For the Poolsquad® Model
PH REGULATION INSTRUCTION
The pH regulation instruction is configured at 7,0 ppm by default. . If necessary, you can change this value by
using the setting menu :
PH PROBE CALIBRATION
No calibration is to be made during the first started of the device, the probe is already calibrated in factory.
Afterward, the calibration of the pH probe should be done each year, at the beginning of the bathing season
(see §6.1).
To Next Page
Loading...
