Why alpha characters show as lower case on POS-X EVO Laser Barcode Reader?
If alpha characters are showing as lowercase on your POS-X Barcode Reader, the computer might be in Caps Lock mode. Enable the Caps Lock detect feature of the scanner to determine if the PC is in Caps Lock mode.
What to do if POS-X Barcode Reader beeps two times and alternately flashes the LEDs?
If your POS-X Barcode Reader beeps twice and alternately flashes the LEDs at power up, there is likely a ROM failure. A flash ROM upgrade is required.
Why everything works except for a couple of characters on POS-X EVO Laser?
If everything works except for a couple of characters on your POS-X Barcode Reader, these characters might not be supported by that country’s key lookup table. Try operating the scanner in Alt mode.
General| Connectivity Technology | Wired |
|---|---|
| Scan Pattern | Single Line |
| Resolution | 4 mil |
| Power Supply | 5VDC ± 5% |
| Connectivity | USB, RS232, Keyboard Wedge |
| Scan Rate | 100 scans/second |
| Light Source | 650nm Laser Diode |
| Operating Temperature | 0°C to 50°C |
| Storage Temperature | -20°C to 60°C |
| Humidity | 5% to 95% (non-condensing) |
Details the physical parts of the scanner with item numbers and descriptions.
Provides instructions on cleaning the scanner's window and housing.
Locates and describes important labels on the scanner, including safety information.
Step-by-step guide for connecting and disconnecting the scanner's modular cable.
Explains the different beeps the scanner uses to signal status and successful scans.
Describes the meaning of the scanner's red and green LED lights during operation.
Lists common scanner failure indications like razzberry tones and beeps.
Table showing scanning distance based on barcode size and density.
Addresses issues related to Serial Emulation USB and Keyboard Wedge interfaces.
Details the scanner's performance characteristics like light source, scan speed, and decode capability.
Provides physical dimensions and weight of the scanner.
Lists input voltage, operating power, and environmental operating conditions.
Outlines the two methods for configuring scanner settings: Single-Code and Multi-Code.
Instructions for resetting the scanner to its original factory settings using a barcode.
Options for setting symbol length locks for 2 of 5 barcodes.
Options for minimum symbol length and symbol length locking for barcodes.
Setting for requiring multiple scans for confirmation of a good read.
Controls the timing of data sent to the host to prevent buffer overflow.
Options for automatic scanning, continuous blinking, and manual trigger activation.
Allows custom prefix IDs to be added and assigned for data transmission.
Using standard characters like STX as prefixes.
Using standard characters like CR/LF as suffixes.
Allows custom suffix IDs to be added and assigned for data transmission.
Settings for check digits, UPC-E expansion, and GTIN formatting.
Options for leading zeros on UPC-E and converting EAN-8 to EAN-13.
Configuring the scanner to emulate a keyboard for data input.
Using code bytes 0-9 for specific configuration settings and character assignments.
To Next Page