Posey KeepSafe Essential - Page 24

www.posey.com 1.800.447.6739
KeepSafe Essential
24
MOUNTING
Wall Mounting (Continued)
8208CS COMMAND
™
STRIP ALARM MOUNTING SYSTEM
1. To install first apply isopropyl alcohol with
clean cloth to the back of the 8208 Wall
Bracket and wall surface where bracket
will be attached. Wipe gently and let dry.
2. Remove the “Red” release liners from the
two (2) Command Strips (Fig. 17).
3. Align the adhesive with the top edge of
wall bracket and press adhesive firmly in
place against bracket. Applying pressure
for 10 seconds to activate the pressure
sensitive adhesive (Fig. 18).
4. Remove BLACK release liners from the
two (2) Command Strips and secure
bracket to wall. Press bracket against
wall for 30 seconds to activate pressure
sensitive adhesive, waiting one (1) hour
for use (Fig. 19).
5. To remove, locate the two Command
Strip release tabs near the bottom of the
bracket. Hold the Wall Bracket with one
hand and pull the release tabs with your
other hand.
DO NOT pull release tabs
towards you. Pull straight down along the
wall at least 15 inches. The strips will stretch and release from the wall.
The Posey 8208CS will adhere to the following types of
wall surfaces: painted, stained or varnished wood, glass tile, painted
cinder block, plaster, metal or wallboard. It is not suitable for wallpaper or
brick. Surface temperatures should be above 50º F (10º C) for proper
adhesion and adhesion could lose strength at temperatures above 105º F.
Fig. 18
Fig. 17
Fig. 19