G-2108/G-3106 User’s Manual
ii
Important Safety Instructions
Only qualified and trained service technicians should attempt to repair the printer.
Do not place the printer on or near a heat source.
Be sure that the output of the power adapter is 24VDC and your power source matches the rating listed on the
power adapter. Be certain your power source is grounded.
To avoid getting an electric shock, do not use a worn or damaged power cord. If the power cord becomes damaged
or frayed, replace it immediately.
Do not insert anything into the ventilation slots or openings on the printer.
The printer and power adapter should never be operated in a location where either one can get wet. Personal injury
may result.
The printhead becomes hot while printing. To protect from damaging the printhead and risk of personal injury,
avoid touching the printhead.
To get increased printhead longevity and higher quality printouts, always use approved labels, tags and thermal
transfer ribbons. Approved supplies can be ordered from your Postek authorized reseller.
Static electricity that accumulates on the surface of the human body or other surfaces can damage or destroy the
printhead or electronic components in this device. DO NOT touch the printhead or the electronic components with
bare hands.
Place the printer on a flat, firm, solid surface.
Never jam or block the air vents, or operate in a high temperature environment.
Turn off the power when not in use for extended periods.
Follow all recommendations and setup instructions included in this manual.
Warnings
This is a Class A product. In a domestic environment this product may cause radio interference in which case the user
may be required to take adequate measures (see FCC Notice).
Static electricity that accumulates on the surface of the human body or other objects can damage the print head or
electronic components in the G-2108/G-3106 printer. Observe proper electrostatic safety precautions when handling.
To Next Page
Loading...
