EasyManua.ls Logo

Potensic ATOM - Page 24

Potensic ATOM
38 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
21. One-key takeoff, landing/return
The App will display different buttons based on drone status. Tap to initiate one-key takeoff, landing or
return.
Tap to unlock, take off and hover at a height of 1.2m
Make sure to fully charge the mobile device prior to flight, because the power of the mobile device will be
consumed even if it is charged by the remote controller.
Mobile cellular data is required when using the PotensicPro App. Please contact your wireless carrier for data
charges.
While using the App, make sure to read and master the pop-up prompts and warning information of App to
know the current status of the drone.
It is recommended to replace any outdated mobile device which may have a negative impact on user
experience of App and lead to potential dangers. For any poor user experience and safety problems due to the
use of an outdated mobile device, Potensic does not bear any liability.
22. Display important information or status of drone
Tap to land or auto return.
23
Different colors of the attitude indicator:
Legend Description
Green indicates that the drone is flying at a relatively small tilt angle,
high precision control over the gimbal and optimal video quality can
be achieved.
Yellow indicates that the drone is flying at a relatively large tilt angle,
the control precision of the gimbal may be affected, and the video
quality may be reduced.
Red indicates that the drone is flying at a very large tilt angle. If the
attitude indicator frequently turns red during flight, the drone may be
encountering strong winds and the video quality can be compromised.
Please fly the drone back and land it as soon as possible.
When the icons of the drone and the remote controller both turn green, it indicates
that the remote controller is facing the drone which guarantees the optimal
communication signal.
After the drone is powered on and enters GPS mode, the current GPS coordinates
will be updated as the HOME point. Pay attention to the update prompt of the HOME
point.
When the drone takes off in OPTI mode and then enters GPS mode, the HOME point might not be the take-off
point. Pay attention to the return safety.

Related product manuals