26
UTC offset: +NNhNNm
Use to enter the time interval (offset) in hours and minutes which must be added to UTC time to
enable the display to show local time correctly when a GPS fix is obtained. To set the interval, move the
cursor to UTC offset and follow on-screen instructions. +NNhNNm is the current offset. The offset
interval must be reset manually when there is a standard/daylight time change.
Fld Str 1: mV/m
Use to choose measurement units for the FS1 field strength number on the display. For detailed
instructions see Sec. 4.2.5.1, p.21.
Fld Str 2: dBuV/m
Use to select measurement units for the FS2 field strength number on the display. For detailed
instructions see Sec. 4.2.5.1, p.21.
Datum: LLLNN
Use to choose the geodetic datum for GPS location calculations. LLLNN is the current datum.
Move the cursor to Datum and press SELECT; move the cursor to the desired datum and press
SELECT.
Spacing kHz: 10 9
Use to input the local station frequency separation (affects the FREQ SET cursor initial
position). Move the cursor to Spacing, move the underline to the appropriate number, and press MENU.
To Next Page
Loading...
