30
4.5.6 Data record fields: The data record for each measurement contains 31 fields, listed below
in the order in which they appear in the .csv file. For details on any item , go to the applicable section of
this User’s Guide.
Dir ID Internal use only
Rec ID Internal use only
Point Number Data point: number from the Save screen (incremented with each save)
Tx ID Internal use only
Call Sign The call sign of the station chosen in Tx select
Tx Frequency Frequency in kHz of the station chosen in Tx select
Meas. Freq. Operating frequency in kHz (may differ from Tx Frequency if FREQ SET has been
used)
Radial Radial from the Save screen
Pattern Pat: setting from the Save screen
Initials Initials from the Save screen
Note Note from the Save screen
Meas. Point Meas. point from the Save screen
UTC Time UTC Date (m/d/y) and Time (h:m) from GPS
Local Time UTC Date and Time from GPS plus UTC offset value from MENU
Harmonic Harmonic: setting from MENU
RF Source Input: setting from MENU
GPS Valid TRUE = a good fix, GPS data is valid; FALSE = no fix, data invalid
Latitude PI4100’s latitude in decimal degrees from GPS
Longitude PI4100’s longitude in decimal degrees from GPS
Elevation PI4100’s elevation above sea level in meters from GPS
Fld Str 1 FS1 (upper) field strength value as displayed
Units 1 Units for FS1 or RF1 value
Fld Str 2 FS2 (lower) field strength value as displayed
Units 2 Units for FS2 or RF2 value
mV/m Field strength in mV/m or RF Input in mV, without rounding
dBuV Field strength in dBuV/m or RF Input in dBuV, without rounding
Tx distance Distance in km of the PI4100 from the Tx antenna location
Azimuth Azimuth (true) of the PI4100 from the Tx antenna location
Temperature The PI4100’s internal temperature in degrees Celsius
Tx Lat/Long TRUE = Lat/Long data for the station chosen in Tx select is present; FALSE = the data
is absent
Modulation Modulation format of the station chosen in Tx select
To Next Page
Loading...
