8.6 Operator section
Language
(20)
The language of the menu guidance can be modified under prog. no. 20.
Info
(22)
Temporarily: The information display returns to the basic display after 8 minutes.
Permanently: The information display remains permanently displayed after call-
up with the information button.
Contrast of display
(25)
Under prog. no. 25 the contrast of the display can be adjusted.
Operation lock
(26)
If this function is activated the following operating elements are locked:
- Operating mode buttons for heating and DHW mode
- Control knob (comfort-setpoint room temperature)
- Presence button (only room device)
Programming lock
(27)
In case of switched on lock, the parameters can be displayed, but not changed.
- Temporary unlocking:
Press the OK- and the ESC-button simultaneously for at least 3 sec. The lock will
be re-activated after leaving the setting level.
- Permanent unlocking:
At first temporary unlocking, then prog. no. 27 to "Off".
Units
(29)
Prog. no. 29 enables you to select SI units (°C, bar) or US units (°F, PSI).
Operator section save basic
settings
(30)
The data of the control will be written into the room unit (only available for room
unit).
Caution! The data of the room unit will be overwritten! With this, the individual
programming of the control in the room unit can be ensured.
Operator section activate ba-
sic settings
(31)
The data of the operating unit or room unit will be written into the control.
Caution: The data of the control will be overwritten! The factory settings are stor-
ed in the operating unit.
- Activation of the prog. no. 31 at the operating unit:
The control will be reset to the factory settings.
- Activation of the prog. no. 31 at the room unit:
The individual programming of the room unit will be written into the control.
This parameter is only visible if a suitable standard setting is available in the pro-
gramming unit.
Programming
7308272-03 03.14 Paramount three 30-115 kW 77
To Next Page
Loading...
