Otherwise, you may get an electric shock.
The drive does not remove the voltage from the input terminals.
Before working on the drive, isolate the whole drive from the supply.
If you do not remove the power supply, you may get an electric shock.
Do not remove the cover except for periodic inspections or wiring,
even if the input power is not applied. Otherwise, you get an electric
shock.
Operate the drive with dry hands.
Otherwise, you may get an electric shock.
Do not use cables with damaged insulation.
Otherwise, you may get an electric shock.
Do not subject the cables to abrasions, excessive stress, heavy loads
or pinching. Otherwise, you may get an electric shock.
Install the drive on a non-flammable surface. Do not place
flammable material nearby. Otherwise, a fire could occur.
Disconnect the input power if the drive is damaged.
Otherwise, it could result in a secondary accident or fire.
Do not allow lint, paper, wood chips, dust, metallic chips or other
foreign matter into the drive.
Otherwise, a fire or an accident could occur.
The drive becomes hot during operation. Wait until it cools down
before performing any actions.
Touching hot parts may result in skin burns.
Do not apply power to a damaged drive or to a drive with parts
missing, even if the installation is complete.
Otherwise, you may get an electric shock.
To Next Page
Loading...