Power Electronics SD 300 Series - 11 Accessing Parameters Using the Profinet Record Data Object

SD300 – PROFINET
POWER ELECTRONICS
48
ACCESSING PARAMETERS USING THE PROFINET RECORD DATA
OBJECT
11. ACCESSING PARAMETERS
USING THE PROFINET
RECORD DATA OBJECT
Using the Profinet Record Data object you can access the SD300 drive
parameters for data reading and writing without the Profidrive communication
protocol.
The drive parameter data is assigned to the Profinet Record Data from the
index address 0h5000. Using the Profinet IO RW service, you can directly
access the addresses to perform reading and writing.
E.g.) The drive common parameter address 0h0001 is assigned to a Profinet
index address 0h5001.
11