Power Electronics SD 300 Series - 8 Supported Profidrive Parameters; Parameters

SD300 – PROFINET
POWER ELECTRONICS
38
SUPPORTED PROFIDRIVE PARAMETERS
8. SUPPORTED PROFIDRIVE
PARAMETERS
Parameters
PNU
R/W
Description
922
R
Displays the selected Profidrive Cyclic Telegram type.
1 → Standard Telegram
100 → Vendor Specific Telegram
*This parameter does not support writing via Profidrive
protocol. Set this parameter using the drive keypad. Go
to CM.22 and set it to “0” to select “Standard Telegram,”
and to “1” to select “Vendor Specific Telegram.
944
R
Fault message counter. The parameter value increases
by 1 each time a fault condition occurs. The controller,
such as a PLC, on the Profinet is notified by this
parameter.
947
R
Fault number
* Refer to <Fault Message Counter (PNU[944]) and Fault
Number (PNU[947])>.
953
R
Warning word
* Displays the “Warning information” parameter value at
communication address 0h0334.
964
R
An array of five 16-bit word values that expresses the
SD300 communication module information.
0: Manufacturer (the Profinet vendor ID “849” for Power
Electronics), as defined by the Profibus.org, is displayed
(referenced from communication address 0h351).
1. Device Type: “1” is displayed for SD300 Profinet
communication module.
2. Version: Displays the software version. E.g.,) “102” for
Version 1.2
3. Firmware Date (yyyy): Displays the year of the
software release. E.g.,) “2015” for the year 2015
4. Firmware Data (dd/mm): Displays the date and month
of the software release. E.g,) “2512” for December 25
8