Power Electronics SD 300 Series - Page 32

SD300 – PROFINET
POWER ELECTRONICS
30
Source Status
Target Status
Event
Action (Drive operation)
“Operation”
“Ready for
Operation”
"OperationDisable"
Motor is stopped (the SD300
drive stops the motor according
to the Ad.8 “Stop Mode”
settings).
“Operation”
“Switch On
Inhibited”
"CoastStop"
Motor is stopped (Free Run
Stop).
“Operation”
“Switch On
Inhibited”
"QuickStop"
Motor is stopped (the SD300
drive stops the motor according
to the Ad.8 “Stop Mode”
settings).