4
1 IMPORTANT SAFETY WARNING continued
• Do not install the UPS where the relative humidity exceeds 95%, and it must also be non-
condensing.
• Do not install the UPS near bodies of water or salt water. (conformal coating may be required
to protect your UPS)
• Do not install the UPS in high dust, conductive dust environments (conformal coating may
be required to protect your UPS)
• Do not install the UPS system where it would be exposed to direct sunlight or nearby heat
source.
• Do not block ventilation holes on the UPS housing.
• Do not connect appliances or devices which would overload the UPS. Care needs to be taken
with laser printers, or other loads with high inrush current to size the UPS accordingly.
• The UPS and any supplied external battery modules come with earth connections. Please
ensure all earth connections are installed.
• All electrical work shall be undertaken by a qualified electrician (in your local jurisdiction)
Please use only VDE-tested, CE-marked power cables to connect the loads to the UPS system.
Pluggable equipment includes a protective earth conductor that carries the leakage current from
the load devices (computer equipment). Total leakage current must not exceed 3.5mA.
Use of this UPS in medical application of any life-sustaining equipment where failure of the
equipment can reasonably be expected to cause the failure of the life-sustaining equipment or to
significantly affect its safety or effectiveness is not recommended. Do not use this equipment in
the presence of a flammable mixture with air, oxygen or nitrous oxide.
WARNING: This is a category C2 UPS product. In a residential environment, this product may
cause radio interference, in which case the user may be required to take additional measures.
1.3 Safety instruction
Please read carefully all warnings and operating instructions in this manual before installing
the unit.
Handling Safety
As UPS can weigh over 10kgs and the external battery modules can weigh over 40kgs please
lift correctly.
To Next Page
Loading...
